IS OVER THE TIME TO GO AROUND THE APARTMENT TO CLOSE OR OPEN ALL THE SHUTTERS!

WITH THE TM1000 CONTROL UNIT IT IS SUFFICIENT TO PRESS THE BUTTON FOR A MOMENT TO ACTIVATE THEM TOGETHER! ! ! !

The TM1000 roller shutter automation control unit allows both to control the single roller shutter through the double button located near it and to centralize the opening and closing of several roller shutters through the double button located in one or more appropriate points.

The connection between the TM1000 control units takes place through a simple three-wire BUS line (also telephone type) and not bringing the commands for all the motors to one point.

Thus in one or more points of the house (for example near the entrance) it is possible to have a centralized control that ensures that you have closed all the shutters before leaving (or to open them once you enter the house).

It works with MAN AWAY, so there is no need to keep the button pressed. In fact, a temporary pressure is enough to start the engine.

It is also possible to stop the motor stroke at any time by pressing one of the buttons again.

The removable terminals allow for easy maintenance, while the small size allows for easy placement. It is not necessary to buy accessory cards or containers for fixing, nor to carry out complicated programming; the control unit is ready for use.

TECHNICAL SPECIFICATIONS:

Power supply: 240V ac 50Hz

Absorption: 10mA

Dimensions: 70 x 90 x 42 (h) mm

F1 fuse (motor): 2.5A FAST

F2 fuse (mains): 0.2A AUTOMATIC

Data sheet